BMW Z3 interior trim kits: which kit fits your Z3 (1996–2003)

The BMW Z3 was built from 1996 to 2003, and in that time its cabin changed more than most owners expect: the centre console was revised, some cars got a cup holder, and the roadster and coupé differ in detail. That is why we make several Z3 kits rather than one. This guide brings them together so you can find the right kit for your car in a couple of minutes.

All BMW Z3 interior trim kits

Click a kit to see its parts diagram and every available finish.

Kits are made for left- or right-hand drive – choose the version on the product page.

Which Z3 version do I have?

Start with the year of manufacture, then look at the centre console. For 2000–2003 cars the deciding detail is the cup holder: if your console has one, choose the kit “with cup holder”; if not, the kit “without cup holder”. The two kits are cut differently around that area and are not interchangeable.

For 1996–1999 roadsters (E36/7) and 1999–2002 coupés (E36/8), compare the parts diagram with your dashboard, especially around the radio, the climate controls and the gear lever surround. If you are unsure, send us a photo of the dashboard and centre console and we will tell you which kit fits.

Small kit or full kit?

Several Z3 versions are available as a smaller kit (20–21 pieces) and a full kit (41–42 pieces). The smaller kit covers the most visible areas of the dashboard and console; the full kit continues the finish onto more surrounding parts for a consistent look throughout the cabin. If your original trim is worn in many places, the full kit is usually the better choice.

For a Z3, carbon look and aluminium look suit the sporty character of the car; wood looks give a more classic roadster feel; a colour matched to the exterior paint is a popular choice for open-top cars, where the dashboard is always on display.

Choosing a finish

• Note the year of manufacture and whether the car is a roadster or a coupé.
• Check the centre console for a cup holder (2000–2003 cars).
• Decide between the smaller and the full kit.
• Choose left- or right-hand drive and your finish on the product page.

Fitting the kit

1. Clean and degrease every surface; remove silicone-based interior care products.
2. Dry-fit each piece before removing the backing.
3. Work in a warm interior or garage – adhesive bonds poorly on cold plastic.
4. Align openings and edges first, then press the whole surface firmly.
5. Keep vents, switches and airbag areas free.

Kits are delivered with a glossy surface. If you prefer a matt look, spray one or two coats of clear matt lacquer on the parts before installing them.

FAQ

Will a 1997–1999 kit fit my 2001 Z3?

No. The dashboard and console changed, so choose the kit for your year range.

What is the difference between the kits with and without cup holder?

The pieces around the centre console are shaped differently. Check your console before ordering.

Are the kits real carbon or real wood?

No. They are printed carbon-look, wood-look or colour finishes protected by a clear, high-gloss PU dome.

BMW and Z3 are used only to identify the vehicles. CockpitDekor is an independent accessories supplier and is not affiliated with BMW AG.